banner Ad
banner

Crown Molding

See the Molding Section for helpful hints!

[ Article Index ] [ Ask our Expert Forums ] [ HandymanUSA Home ]

Posted by: Dan Link on February 02, 2001 at 16:44:30

In Reply to: Crown Molding Posted by: Edo on July 27, 1999 at 18:01:34

I am installing 3 inch crown molding. I have a compound miter saw; but I do not know what the angles are for each cut. What are the angles? Is it better to bag cutting angles and just use a coping saw?

Cut at 45 degees!




To post a new question in our active forums click on the link below:
HandymanWire Forums


Experts | Email Us | Disclaimer | Handyman USA home
Articles | We welcome your feedback. | Privacy
http://www.handymanusa.com
Handyman USA
your resource for advice on home improvement and repairs.
Copyright ©2007, Handyman USA LLC. All rights reserved.
Sponsored by WaterImp, an alternative to Water Softeners.